+34 644 098 320
+34 91 417 04 02
WhatsApp +34 644 098 320
Call + 34 972 25 62 12
🔥 10% off EVERYTHING with code BLACKFRIDAY 🛒
Table of Contents
1 – Puller Magnet
2 – Extractor Bar
3 – Nano earpieces (2 magnetic units)
4 – Jack Connector, Keypad and Integrated Microphone
5 – Induction Collar
+ Wired Microphone
6 – Jack adapter
7 – External microphone
Check that it is a original product of PingaOculto checking that the brand that appears on the product is the same.
If you have doubts about whether it is original, you can contact us and we will verify it. Contact us through: WhatsApp +34 644 098 320 o Email.
The penguins (in the image indicated by the number 3) are the two smallest pieces and should part with the nail. You can find them in the Kit in a bag. Also included are extractor bar (2 in the picture) and the puller magnet (1 in the image).
The Nano Induction Collar is divided into two separate parts that we will join in the next step. This inducer necklace requires two 9V batteries not included to work. Example 9V battery:
Connect the transmitter and receiver using the red connectors.
Check that they are correctly oriented as in the image according to the shape of the connector.
Plug it in a 9V battery in each connector. Note that You must connect each port of the battery with the opposite of the connector to fit correctly. Check that they have been correctly fixed. The Estimated autonomy of the batteries is 3-4 hours depending on the volume and must be disconnected while the kit is not in use, since the induction collar uses energy even if it is not used.
Put The entire Kit on a table or flat surface. Connect the kit to your mobile according to the Kit purchased:
On some iPhone models and a compatibility failure has been detected in the use of the device with non-original adapters when making a phone call. You need to use an original adapter or use another mobile.
Enter first a penguin (only one of the two that appear in the image indicated by a 3) in the left ear (we hear better through the left ear than through the right) through the following procedure:
You may need to repeat this step several times
FOR check that the earpiece has been correctly inserted, put your hand to your ear (so that the earpiece does not fall to the ground) and turn your head to the opposite side. If the earpiece comes out of your ear easily when turning the head is that it has NOT been entered correctly. You must repeat the introduction steps.
also can check if it is correctly inserted by verifying that another person does not see the earpiece in the ear. If you can see it, DO NOT it is well introduced.
Tip: There are times when The earpiece just needs a little push to be correctly entered. If so, place the extractor magnet behind your ear, close to the neck. You will notice how the earpiece moves and you can finish placing it.
Tip 2: There are certain people who accumulate more amount of earwax, especially in the inner part of the ear, causing more difficult to introduce the earpiece. Remember clean the ear with Cleaning Sprays and sticks for the ears. Usually you will only need practice more to enter it correctly. If you can't enter it it is recommended that you have a ear cleaning to remove wax plugs.
If you can't enter it, contact us to help you: WhatsApp +34 644 098 320 o Email.
When the earpiece has been correctly inserted in the left ear, place the Kit as it appears in the image, remembering that the induction collar should always be on the neck under clothing. Batteries and mobile can be held in pockets or pants.
Play the song, recording or phone call by turning the volume up to the maximum on your mobile to check if the volume it provides is enough a penguin (sufficient in most cases) if we have inserted the earpiece correctly, if the volume is maximum, the batteries have enough charge and the induction collar is on the neck).
If you hear very low, Also insert the other earpiece into the right ear.
(A single earpiece in the left ear is recommended, since when trying to insert one in each ear the first will dislodge when inserting the second). (It is VERY likely that if we do not hear well with an earpiece in the left ear it is because we have not inserted the earpiece correctly, the volume is not maximum on the mobile, the batteries do not have enough charge or the induction collar is not on the neck).
El Nano inductor collar should always be on the neck, since it is in charge of emitting short-range inductive waves to the earpiece, causing the sound. The inductor necklace being made of copper it is moldable and you can adjust it to the shape of your neck. For more security it is recommended to fix it with cloth or plastic tape to your skin so that it does not move during use. For repeated use you can even sew it to sweatshirts or jackets. Please remember that the Induction Collar is not washable and water will cause it to stop working.
You can use this Kit by phone call or with recordings. The integrated microphone is located behind the push button. El push button is not necessary if the functions are performed directly from the mobile and may not be compatible with some mobiles, especially if you use an adapter to be able to connect to the mobile.
Recommended search the app store from our mobile one compatible application with these functions to use the kit to play songs or recordings. For iPhone it is recommended: https://apps.apple.com/es/app/grabadora-de-voz/id685310398
remove the earpiece approaching the extractor bar (indicated in the image with a 2) with puller magnet (indicated with a 1) at its base to the ear as you can see in the first image.
Another VERY effective extraction method es hold with one finger the puller magnet inside the ear and shake your head while keeping it rotated as in the second image. It can be hard to remove the first few times, but after several attempts it will succeed.
Also the earpiece may have already been removed and fallen to the ground, check if it's still in your ear by plugging in the Kit and checking if you hear it when playing a song.
If you cannot extract it, contact us to help you: WhatsApp +34 644 098 320 o Email.
It is recommended to clean the earpiece with water or ethyl alcohol, the extractor magnet and the extractor bar before and after each use for better hygiene.
Lastly, Remember to disconnect the batteries when you finish using the device.
Can check the VideoTutorial along with instructions to better understand how the earpiece works:
If you have questions, don't hesitate to contact us! 😉
the penguins can be complex products in its operation. Check below the frequent problems nano penguin and its solution.
Nano earpieces work because of the material they are made of, a piezoelectric material, and not due to any internal electronics in the earpieces. For this reason it is impossible for nano earpieces not to work and The problem will be the inductor collar, the batteries or the mobile. Follow the steps and tests indicated in the next section.
Extractor Bar, Extractor Magnet and Earpieces
Verify that you have correctly connected the transmitter and receiver using the red connectors. Check that they are correctly oriented according to the shape of the connector. If they are already connected, there is no need to reconnect them.
Check that the 9V batteries are correctly seated in each connector and that the batteries are charged. Note that You must connect each port of the battery with the opposite of the connector to fit correctly. If the batteries have been left connected For a long time, they will be unloaded. Even if it has not been used, it is consumed.
Place together the Extractor Magnet and the two earpieces and place them in contact with the induction collar like in the image. The extractor magnet, being also made of a piezoelectric material, reacts to inductive waves in the same way as the earpieces, vibrating and causing the sound and for this reason we will use it together with the earpieces to carry out the test.
Play a song on your mobile/MP3 and while playing turn up the volume to the maximum from your mobile. Bring your ear closer to the extractor magnet and to the earpieces that are in contact with the induction collar and Check if you hear and/or vibrate.
Si vibrate and/or is heard, the kit It's working correctly.
If they do not vibrate or hear anything, repeat the steps with another mobile and verify that the batteries are charged, that the connectors are correctly attached, that you have placed the extractor magnet and the two earpieces attached to the cable and that the volume is maximum while it is being used. play the song. If you need more help contact us: WhatsApp +34 644 098 320 o Email.
If in the previous step when carrying out the test you have noticed how the extractor magnet together with the earpieces vibrate or sound, the kit is working correctly and the problem is:
This failure is impossible. If one device works, the other works too. This is because the earpieces work because of the material they are made of, a piezoelectric material, and not due to any internal electronics in the earpieces. The material reacts to the inductive waves of the induction collar by vibrating and making sound.
Most likely, the earpiece has not been correctly inserted into the ear, we are confusing the extractor magnet with the earpieces or two earpieces together or that let's hear more through one ear (We normally hear more through the left ear).
If the volume obtained by the earpiece in one ear is sufficient, it is recommended to use it with a single earpiece and save the other.
Si The kit works with songs, recordings or audios in general from our phone, but not with phone calls, is due to a problem in using a non-original adapter. This occurs especially in iPhone when using a non-original Apple adapter to get the 3.5mm headphone jack port.
Es very important to use an original adapter from the manufacturer to make it compatible with phone calls. Otherwise, it will only work with audios such as songs, recordings or videos.
It is also important Check your mobile settings so that the audio output is correctly configured.
If the problem persists, it is recommended try with another mobile.
El push button is not necessary if the functions are performed directly from the mobile and It may not be compatible with some mobile phones, especially if adapters are used. Also depends on the application used to play songs or recordings.
The built-in microphone can not work on mobiles with a non-original adapter, as for example usually happens on iPhone. It is recommended to purchase a original adapter or use another mobile. This microphone will stop working when you connect the microphone via cable.
The wired microphone must be connected to the red connector. If the wired microphone does not work, you must verify that has been fully connected because it is hard for safety to prevent accidental disconnection. Verify that a original adapter to obtain the 3.5mm headphone jack port if our mobile does not have it. Additionally, try restart the mobile and check the audio output settings of the mobile. If it still does not work, it is recommended try with another mobile.
You may have to try several times until it is successfully removed.
Earpieces work because of the material they are made of, a piezoelectric material, and not due to any internal electronics in the earpieces. For this reason it is impossible for nano earpieces not to work and the problem will be the inductor collar, the batteries or the mobile.
Most likely the batteries have been left connected and the batteries have run out. Remember to disconnect the batteries when you finish using the device to prevent them from downloading. You should never pull the wires to disconnect it, pry it up.
If the batteries have charge follow the steps indicated in the section 2 I can't hear anything or very low.
If the Kit does not work, contact us to help you: WhatsApp +34 644 098 320 o Email.
Below is indicated important product information in relation to the security and compliance that guarantee proper and safe use of the product:
⚠ WARNING: Do not use or store the product near other electronic equipment because the magnetic field of adjacent electrical equipment will seriously damage or interfere with the product. Also do not use this product if you have impaired hearing which may be affected, if you use hearing aids, or if you are using a pacemaker or any electronic medical device.
® PingaOculto. All rights reserved.
Product specifications:
Model Name: Nano / Nano + Microphone
Model number: N-01/N-02
Product identifier: B084D9N8W9 / B08J8D77BP
Electrical Rating: 2 x 9V, 300-1000 mAh (Requires 2 9V batteries not included)
Operating temperature: 0 to 35ºC
Product Use: Do not expose your device or adapter to liquids. If your device or adapter gets wet, carefully unplug all cables without getting your hands wet, and wait for the device and adapter to dry completely before plugging them back in. Do not try to dry your device or adapter with an external heat source, such as a microwave oven or blow dryer. If the device or adapter is damaged, stop using it immediately. Use only the supplied accessories to power your device. To avoid the risk of electric shock, do not touch the device or the cables connected to it during a thunderstorm. The cables and/or adapters are only designed for indoor use.
Legal notice: PingOc Now SL is not responsible for the fraudulent or erroneous use of the product due to the lack of understanding or reading of the information in the instructions and precautions. This product is not a toy and must not be used contrary to current applicable laws. If you have any questions you can contact us before using the product.
For EU customers: Hereby, PingaOculto, declares that the type of radio equipment is in accordance with Directive 2014/53/EU.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC Compliance: This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet the general RF exposure requirement. The device can be used in portable exposure conditions without restrictions.
Radio Frequency Exposure Compliance: As a health protection measure, this device complies with the limits for exposure of the general public to electromagnetic fields in accordance with council recommendation 1999/519/EC. This device can be placed on the body avoiding prolonged use of it for more than 5 hours.
How to recycle your device properly: Disposal of certain electronic devices is regulated in some areas. Make sure you comply with local regulations and laws.
Additional Safety and Compliance Information: For additional information on safety, recycling and compliance or other important issues related to your device, do not hesitate to contact us through any of the available means of contact. Means of contact with: Email contact@pingaoculto.com, Call/WhatsApp +34 644 098 320.
Limited Warranty: All official brand items PingaOculto have 2 year minimum warranty. This guarantee may be extended or reduced depending on the country where the sale takes place, as is the case by law in Spain where it is extended to 3 years as established by Decree-Law 7/2021 with respect to the Guarantee on the Sale of Goods. of consumption. We reserve the right to deny the guarantee of a product if improper or negligent use by the client is verified, similar to those reflected in: https://www.pingaoculto.es/garantias-y-devoluciones/ If you need to contact us due to a failure, you can do so by email: contact@pingaoculto.com or by Call/WhatsApp: +34 644 098 320.
Anywhere in the world
Up to 14 calendar days
Quick and Efficient Management
PayPal / MasterCard / Visa